ShelterLogic 86070.0 Instruction Manual download pdf (Page 10)

05_10B163_0EPage 10

8. INSTALLING THE COVER ON THE FRAME:

A. Lay the cover on the ground next to the

frame with the inside of the cover (the side

with the pipe pockets) facing down and the

webbing on the front and rear of the corner

of the building. Position the cover so that it

is centered on the frame, front to back. See

Detail J.

B. Fold over the side so the pipe pocket is

now accessible. Insert a cover pipe into the

pipe pocket slot, at the rst middle rib from

the front and the rst middle rib from the

rear. Some of the pipe will be exposed. For

long buildings it may be necessary to use

additional pipes in the middle. See Detail K.

Remove pocket pipe to install later.

C. Tie the rope on each of the exposed

pipes and throw the other end of the rope

over the frame. See Detail L.

D. Move to the other side of the frame and

pull the cover over the frame with the rope.

This may require two or more people. See

Detail M. Check that the Logo reads upright

as shown.

DETAIL J

DETAIL K

DETAIL L

DETAIL M

END PANELS

AND WIND

BRACES NOT

SHOWN FOR

CLARITY.

NOTE: CHECK THAT YOUR COVER IS

CORRECTLY PLACED ON THE FRAME.

The ShelterLogic

logo should line up on the left front and

right rear corners near the top rail. If the logo is not legible,

the cover has not been put on the frame correctly.

COVER RAIL SHOWN

ASSEMBLED.

1 2 ... 5 6 7 8 9 10 11 12

No comments

ShelterLogic 86070.0 Instruction Manual Page 10